[email protected] +91 9840521421 Scholarly Open Access, Peer-reviewed, Refereed Journal e-ISSN 2582-8746 Since 2020
  1. Home
  2. Archives
  3. 2026
  4. Vol. 7 Issue 6
  5. Article
Case Study

Design and Simulation of a Graphite Cleaning Robot System

  • Paper ID 1216
  • Volume 7, Issue 6
  • Pages 106-112
  • Published Online: November-December 2026
Open Access Peer Reviewed Crossref DOI

Authors

  • Baosheng Chen1
  • Mengyi Sun2

1 2 School of Intelligent Manufacturing, Zhejiang Institute of Communications, China.

Article Information

Published Online
November-December 2026
Pages
106-112
Article Type
Case Study
Check for updates
check update

Abstract

View PDF

To address the problems of high cost, low efficiency, and prominent safety hazards caused by manual chiseling for graphite cleaning at coal‑charging ports in the coking industry, an automatic graphite cleaning system based on a six-axis industrial robot was designed. Considering high‑temperature service conditions, a stainless‑steel cleaning end‑effector with air‑curtain thermal insulation was designed. The system adopts an S7‑1200 PLC as the main controller and realizes real‑time communication with the ABB six‑axis industrial robot via the PROFIBUS‑DP bus, realizing the integration of rapid tool‑change, furnace‑cover manipulation and cleaning tasks.A virtual workstation was established in RobotStudio to plan a composite cleaning trajectory consisting of straight and inclined segments. Kinematic simulations were conducted to verify the robot’s joint movements, interference, and singular configurations. Simulation results indicate that all robot joint movements remain within the permitted travel range, with no collisions, interference, or singular configurations; The net cleaning time per hole is 105 s, and the complete operation cycle is 165 s, which meets the 180-second coal-charging cycle requirement for coke ovens. This robotic cleaning system enables unmanned cleaning of coal-charging holes, reducing operation time and eliminating safety hazards.

APC from ₹1200 + 18% GST

Peer-reviewed open access₹1200 Indian (₹1400 with DOI)$80 USD internationalpaid after acceptance Peer-reviewed open access₹1200 Indian$80 USD international ₹1200 Indian · $80 intl

  • CrossRef DOI
  • ISSN 2582-8746
  • Open Access
  • Peer Reviewed
  • Plagiarism Checked
  • Google Scholar
Submit Paper